A modular and scalable radio retention system for for most radios. The MOLLE interface provides very good adjustability without compromising durability or structural integrity.

Suitable for a wide range of radios

The three-part chassis allows the internal dimensions to expand and contract as needed. Thus, almost any radio model can be properly secured and ventilated while maintaining the full range of functions.  

The top strap can be threaded through the chassis backer in one of two slots to further accommodate the wide variety of radio sizes, helping you configure the chassis so that it does not impede buttons or toggles.

This chassis works with radios that fall within the following dimensions:

• Height: 140 - 304+ mm (5.5” - 12+”)
• Width:  70 - 101 mm (2.75” - 4”)
• Depth: 32 - 101 mm (1.25” - 4”)

You can further micro-adjust the Velcro on the battery cup and top strap to expand or retract these dimensions. Below you’ll find a few common radios that fit very well:

• Persistent Systems MPU5
• L3/Harris AN/PRC-163
• L3/Harris AN/PRC-152
• Thales AN/PRC-148
• Motorola XTS 5000
• Motorola APX 8000
• Motorola APX 7000

MOLLE/PALS and belt-mountable

The chassis backer is a semi-rigid board that can be mounted to cummerbunds, chest rigs, and packs using two PALS columns, or on the waist via the integrated belt pass-through. The board is stiff enough to provide a firm mounting surface for any radio and keep it in place, regardless of its size.

Quick and easy battery exchange

The tri-flap battery cup is MOLLE-adjustable for height on the front of the chassis backer. The flaps enable you to swap batteries without removing the radio or unplugging any wires, and they can be resecured with an additional layer of redundancy via the fastex buckle that runs through the front.